The image below is a Plejaren Beam Ship. It is not a fake model placed inside a
photograph of a building. The reason
this is known because there are very serious mathematical relationships in the
basic measurements that a typical earth human would not include in a fake
model.
The three colored lines ranging in length from bottom
yellow to blue to green to top read are all related. The square root of the yellow is the
green. The blue is 11/15 of the
yellow. The ratio of the green to the
red is 4/pi.
The spheres associated with each colored line also
indicate a sophisticated design system.
In the bottom yellow line area, the small bumps are calculated from the
yellow line length minus twice the far right short line to get the diameter of
the bump circle. The short yellow line
in the center develops the center to center distance of the bumps. By getting
the circumference of the bump circle and dividing by the bump center distance,
it looks like there are a total of 80 bumps.
Using the same basic approach the modular number of
spheres is calculated to be 21 for the lower ring, 10 for the next and 9 for
the top for a total of 40 spheres. The
diameters of the spheres vary slightly from larger bottom to smallest on top.
The blue circles are shown thick for visibility but in fact are infinitely
thin.
It was known that the overall diameter of the ship was
near 7 meters and so initial scale was established using that number. Then the scale was modified slightly looking
for some telltale checksum to indicate design intent. For optimum convincing, it would be best to
find a checksum with another checksum backing up the first.
In the radii data below the scale factor (division) was
used to calculate the radii in meters and then the number of spheres for a
given ring was calculated and then the total ring volume in cubic meters and
finally the total ring volume in cubic feet. By very slightly varying the
scale, the cubic feet volume was found to be 50 x pi, marked in yellow on the
bottom far right. As hoped another
checksum was found in the total volume of the cubic meter column marked as the
very near the square root of 100 x natural log base “e”. But the number is far more precise in that it
can be converted to the precise wavelength of the most abundant hydrogen
isotope.
Not only does this analysis point to the ship design, but
it also points to something about how it works.
This will involve some very complicated scientific efforts only now just
beginning to be developed in high tech university laboratories. There is good information available for all
the key words on Wikipedia and those with some technical background can go there
and research at will.
The key word here is sonoluminescence. Basically this topic can be understood from
studying the more common problem of fluid
cavitation in ship propellers, piping systems and other fluid design
elements. The third major contribution is high
frequency sonic vibration.
It has bother mechanical engineers for over a century why
some massive steel ship propeller weighing tons can be eaten away with
something happening in the water. How
can the water suck metal out of a 50 ton steel propeller? The answer is cavitation. We have known a lot about how to prevent it
for decades and now we have computer software which will check a fluid handling
design to avoid it.
The answer is a very simple concept, but very difficult
to get a wrap on mathematically or mentally.
As say water slides along the metal surface, it gradually changes from
the liquid state to the vapor state.
Then when conditions change, the vapor collapses back to liquid. But it doesn’t do this gradually. There is something like a small lightning
bolt that reaches very high temperatures and emits a special form of light.
Most of the light we see and enjoy comes from matter electrons moving from
different motions. The light from any
matter has a specific series of wavelengths for that type of material, say
hydrogen discussed throughout the blogs.
In a sense there is a similarity.
A photon coming into a matter electron cloud seems to only gradually be
absorbed but when the electron cloud is unstable, it emits another photon in a
much more dramatic fashion, but nothing like sonoluminescence or
cavitation. So there is the issue of
just what form this new light has.
To give an example of just how different it is, consider
the topic of “Bubble Fusion” or
Sonofusion which essentially is low temperature fusion which really is occurring
at very high temperature but only in a very isolated zone almost hidden from
view to the observer. There is a lot of research of interest going on at the
UCLA lab of Prof. Putternan Research Group.
The Plejaren Semjase has indicated that this particular
Beam Ship was designed to be flown in view of Billy Meier and known he would be
taking video and the still shot used in this analysis. The propulsion system uses ultrasonic
stimulation of special fluids inside the spheres to generate the magnetic field
it requires to ride the earth’s magnetic fields and the use of the Birkeland
currents of space. However, to facilitate
analysis audible sounds were also produced in the same fluctuating manner to
indicate what was happening ultrasonically.
The interested reader should carefully watch the 1.5 hour
video by Col. Wendelle Stevens produced in the late 1970s and available on the
internet at Youtube but they keep changing the internet address so one needs to
scout around. There is a written account
several places on the internet but the video of the sound analysis is really
best seen visually.
The little man Leedskalnin in south Florida who built
huge stone structures singlehandedly, always talked about “magnetic current”
which is still a little cloudy for mainstream science today. But we are finding there is a lot more to
magnetism than we have yet to discover. See
http://magical-magnetics.blogspot.com/
If you haven’t read the larger effort on Billy Meier, see
http://billy-meier-case-is-real.blogspot.com
People who seem bent to find something wrong with
everything, think they have proved a story a hoax if they find one thing that
appears to be an error. Generally it is
they who undertake such efforts who defy logic.
There are 1000s of events in the Billy Meier case for which if only one
is correct, it is a marvelous effort for advanced people to try and help earthlings
without violating the “non-interference rule” and the resulting invasion of the
“free will”.
The search goes on.
bransonjim9 at gmail dot com
Jim Branson
Retired Professional Engineering Manager



Comments
Post a Comment